Page Comparison

Example - Authentication command with remote image data

The authentication command in the Hermod API, POST /rest/command/authenticate, contains a "description" section.

Here is an example: 

  "authCommand": {
    "params": {
      ... 
      "description": [
        ... 
        {
          "content_type": "image/jpeg",
          "data": "BASE64 ENCODED IMAGE....",
          "content_encoding": "base64",
          "key": "auth_image",
          "description": "Verify that image is equal",          
          "visible": true
        }
      ]
    }

The content_type and the data element with base64-encoded data above can be replaced with a reference to remote data using the content provider instead.

  "authCommand": {
    "params": {
      ... 
      "description": [
        ... 
        {
          "content_type": "application/hermod+content-id",
          "data": "AUTH:4018e11f-1209-45f5-ade7-e59004e10745",
          "key": "auth_image",
          "description": "Verify that image is equal",
          "visible": true
        }
      ]
    }

It's then up to the content provider to return the correct base64 image data, content_type and content_encoding.

Define authenticate image

An authenticate image can be defined in two ways: by including the actual data or by pointing to a content provider service where the image data is stored. This section describes what to set when using remote data.

If you need to set up a content provider, see Requirements on content provider API.